Place the add-on mesh router next to the computer you used to configure it.
Power on the add-on mesh router, wait until the LED become solid.
Press the add-on router's Pair/WPS button if there is one, or skip this step. Click Next.
Note: If the add-on router was previously configured, please long-press the Reset button until the LED starts flashing. Wait until the LED become solid, and repeat step 3.
Scanning...
Device Name
MAC-Address
Connecting...
Success
Failed
Place the add-on mesh router half between the main mesh router and the place you want to extend wifi signal.
Observe the LED status of the add-on mesh router to choose the best place.
Solid White(Blue): Connected, good signal.
Flash White(Blue): Connected, bad signal.
Others: Connecting or Disconnected.
Hold the Reset button for 5 seconds before release when powered on, then waiting for it restart.